7. Power interposer board (PIB)
9. PCIe cable (BP:BP PCIe A0 to MB PCIe_A0)
Rear drive cage
Removing the rear drive cage
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove all the drives.
4. Disconnect all the cables from the rear drive backplane.
Steps
1. Using Phillips #2 screwdriver, loosen the screws that secure the drive cage to the system.
2. Pull and hold the screws to lift the drive cage away from the system.
Figure 109. Removing the rear drive cage
Next steps
Install the rear drive cage.
Installing the rear drive cage
Prerequisites
Follow the safety guidelines listed in
Steps
1. Align the screws on the drive cage with the screw holes on the system chassis.
Safety
instructions.
Before working inside your
Safety
instructions.
8. PCIe cable (BP:BP PCIe B0 to MB Interposer_A)
system.
Installing and removing system components
111