Installing The 2.5-Inch Rear Drive Cage; Optional Serial Com Port; Removing The Serial Com Port - Dell PowerEdge R660xs Installation And Service Manual

Installing the 2.5-inch rear drive cage

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If required, remove the air
4. Remove the drives.
5. Disconnect the cables from the rear drive cage.
Steps
1. Align the slot on the rear drive cage with the guide on the system.
2. Slide the rear drive cage towards the rear of the chassis.
3. Using a Phillips 2 screwdriver, tighten the blue thumbscrew that secures the rear drive cage to the system.
Figure 100. Installing the 2.5-inch rear drive cage
Next steps
1. Connect all the cables to the rear drive cage.
2. Install the drives.
3. If removed, install the air
4. Follow the procedure listed in

Optional serial COM port

This is a service technician replaceable part only.

Removing the serial COM port

Prerequisites
1. Follow the safety guidelines listed in the
134 Installing and removing system components
Safety instructions.
Before working inside your
shroud.
shroud.
After working inside your
Safety instructions.
system.
system.