Table of Contents
Advertisement
Figure 136. Installing the 901E and MIL 461G power supply rugged bracket
2.
Install the drive
cage.
3. Align the left edge of the drive retention bracket to the features on the left side of the drive module. Rotate the bracket
closed against the chassis. Slide the latch to the left, and then to the right so that it is fully seated. Using a Phillips #2
screwdriver, secure the 901E and MIL 461G drive rugged bracket.
NOTE:
To secure the 901E and MIL 461G drive rugged bracket, ensure to use the black screws shipped with the 901E
and MIL 461G kit.
Figure 137. Installing the 901E and MIL 461G PCI rugged bracket
4.
Install the front
bezel. Using a Phillips #2 screwdriver, tighten one screw to system cover.
NOTE:
The kit consists of extra screws.
Next steps
Follow the procedure listed in
122
MIL 901E and MIL 461G rugged kit
After working inside your
system.
Advertisement
Table of Contents
