Table of Contents
Advertisement
Figure 99. Installing the heat sink onto the processor
Next steps
1.
Install the processor and heat sink
2.
Install the air
shroud.
3.
Install the expansion card riser
4. Follow the procedure listed in
Installing the processor and heat sink module
Prerequisites
CAUTION:
Never remove the heat sink from a processor unless you intend to replace the processor. The heat
sink is necessary to maintain proper thermal conditions.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card riser
4.
Remove the air
shroud.
5. If installed, remove the processor socket cover.
NOTE:
The procedure to install the processor and heat sink module is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Set the Anti-Tilt wires to the unlocked position on the heat sink (inward position).
2. Align the pin 1 indicator of the heat sink to the system board, and then place the processor and heat sink on the processor
socket.
90
Installing and removing system components
module.
2.
After working inside your
Safety
instructions.
Before working inside your
2.
system.
system.
Advertisement
Table of Contents
