Table of Contents
Advertisement
Figure 64. Installing a drive blank
Next steps
If applicable,
Install the front
Removing the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the
2. If installed,
Remove the front bezel
3. Using the management software, prepare the drive for removal.
If the drive is online, the green activity or fault indicator blinks while the drive is powered off. When the drive indicators are
off, the drive is ready for removal. For more information, see the documentation for the storage controller at
support/home.
CAUTION:
Before attempting to remove or install a drive while the system is running, see the documentation
for the storage controller card to ensure that the host adapter is configured correctly to support drive
removal and insertion.
CAUTION:
To prevent data loss, ensure that your operating system supports drive installation. See the
documentation supplied with your operating system.
Steps
1. Press the release button to open the drive carrier release handle.
2. Holding the drive carrier release handle, slide the drive carrier out of the drive slot.
60
Installing and removing system components
bezel.
Safety
instructions.
for Front Accessed configuration.
www.dell.com/
Advertisement
Table of Contents
