Installing The Expansion Card Riser 3 - Dell PowerEdge XR12 Installation And Service Manual

Figure 41. Removing the expansion card riser 3
Next steps
Replacing the expansion card riser

Installing the expansion card riser 3

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the expansion card riser
4. Remove the air shroud.
5. Remove the drive cage.
NOTE: The procedure to remove the expansion card riser 3 is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Holding the blue touch points, align the expansion card riser with the connector and the riser guide pins on the system
board.
2. Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector on the
system board.
3. Using Phillips #2 screwdriver, tighten the blue thumbscrews.
3.
Safety instructions.
Before working inside your
2.
system.
Installing and removing system components 45