Table of Contents
Advertisement
2. Follow the procedure listed in the
3.
Remove the expansion card riser 2
4.
Remove the air shroud
5.
Remove the expansion card riser 1
Steps
1. Disconnect the control panel cable from the system board connector.
NOTE:
Observe the routing of the cable as you remove it from the system.
2. Using the Phillips #2, remove screws from rack ear assembly.
3. Using the Torx #8, remove screws from status LED control panel assembly.
4. Hold the status LED control panel assembly and remove the status LED control panel along with the cable from the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 120. Removing the left ear for Rear Accessed configuration
110
Installing and removing system components
Before working inside your
system.
Advertisement
Table of Contents
