Table of Contents
Advertisement
Power interposer board
This is a service technician replaceable part only.
Removing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card risers
4.
Remove the air
shroud.
5.
Remove a power supply unit
6. Disconnect the cables that are connected to power interposer board (PIB) and from the system board.
NOTE:
The procedure to remove the PIB is same for Rear Accessed and Front Accessed configurations.
Steps
1. Using a Phillips #2 screwdriver, remove the screws securing the power interposer board to the system.
NOTE:
Observe the routing of the cables as you remove it from the system.
2. Lift the PIB away from the system.
Figure 112. Removing the power interposer board
Next steps
Replace the power interposer
Safety
instructions.
Before working inside your
2.
or
Remove a power supply unit
board.
system.
blank.
Installing and removing system components
101
Advertisement
Table of Contents
