Table of Contents
Advertisement
5.
Remove the air
shroud.
6.
Remove the expansion card riser
NOTE:
The procedure to install the expansion card is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Pull and lift up the expansion card retention latch locks to open.
2. If installed, remove the filler bracket.
NOTE:
Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The filler brackets also keep dust and dirt out of
the system and aid in proper cooling and airflow inside the system.
Figure 45. Removing a filler bracket from riser 1
3. Hold the expansion card by the edges, and align the card edge connector with the expansion card connector on the riser.
4. Insert the card edge connector firmly into the expansion card connector until the card is fully seated.
5. Close the expansion card retention latch.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 46. Installing an expansion card into a riser 1
Next steps
1. If applicable, connect the internal cables to the expansion card.
48
Installing and removing system components
1.
Advertisement
Table of Contents
