Table of Contents
Advertisement
Figure 105. Installing the M.2 BOSS card into the system board
Next steps
1.
Install the air
shroud.
2.
Install the expansion card riser
3. Follow the procedure listed in
Removing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Removing the M.2 BOSS
NOTE:
The procedure to remove the M.2 SSD module is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Using the Phillips #1 screwdriver, remove the screw securing the M.2 SSD module to the BOSS card.
2. Pull the M.2 SSD module to disconnect from the connector on the M.2 BOSS card.
2.
After working inside your
Safety
instructions.
Before working inside your
card.
system.
system.
Installing and removing system components
95
Advertisement
Table of Contents
