Table of Contents
Advertisement
Figure 101. Set the Anti-Tilt wires to the locked position and tightening the screws
Next steps
1.
Install the air
shroud.
2.
Install the expansion card riser
3. Follow the procedure listed in
Optional internal USB memory key
Removing the internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm width x 57.15 mm length x 7.9 mm height.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card riser
4.
Remove the air
shroud.
5.
Remove the expansion card riser
NOTE:
The procedure to remove the USB memory key is the same for Rear Accessed and Front Accessed
configurations.
Steps
Remove the USB memory key from the USB port on the riser 1.
92
Installing and removing system components
2.
After working inside your
Safety
instructions.
Before working inside your
2.
1.
system.
system.
Advertisement
Table of Contents
