Initializing Tpm For Users; Initializing The Tpm 2.0 For Users; Control Panel; Removing The Status Led Control Panel - Dell PowerEdge XR12 Installation And Service Manual

5. Pull the plastic rivet out of its slot on the system board.
Installing the TPM
Steps
1. To install the TPM, align the edge connectors on the TPM with the slot on the TPM connector.
2. Insert the TPM into the TPM connector such that the plastic rivet aligns with the slot on the system board.
3. Press the plastic rivet until the rivet snaps into place.
4. Replace the screw that secures the TPM to the system board.
Figure 119. Installing the TPM

Initializing TPM for users

Steps
1. Initialize the TPM.
For more information, see
2. The TPM Status changes to Enabled, Activated.

Initializing the TPM 2.0 for users

Steps
1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3. From the TPM Security option, select On.
4. Save the settings.
5. Restart your system.

Control panel

This is a service technician replaceable part only.

Removing the status LED control panel

Prerequisites
1. Follow the safety guidelines listed in the
Initializing the TPM for users.
Safety instructions.
Installing and removing system components 109