Dell PowerEdge XR12 Installation And Service Manual page 58

Figure 61. Installing a double-width, full-length GPU card into a riser 3
Figure 62. Installing a half-length, low-profile expansion card into a riser 3
8. Close the L-shaped bracket, and using the Phillips #1 screwdriver, tighten the thumbscrew.
Next steps
1. If applicable, connect the internal cables to the expansion card.
2. Install the expansion card riser
3. Follow the procedure listed in
4. Install any device drivers required for the card as described in the documentation for the card.
NOTE: While replacing a faulty storage controller or NIC card or GPU card with the same type of card, after you
power on the system; the new card automatically updates to the same firmware and configuration of the faulty one. For
more information about the Part replacement configuration, see the Lifecycle Controller User's Guide available at
www.dell.com/idracmanuals
CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated
and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the
system warranty.
58 Installing and removing system components
3.
After working inside your system.
https://