NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 56. Removing a double-width, full-length GPU card from the riser 3
Figure 57. Removing a half-length, low-profile expansion card from the riser 3
4. If the expansion card is not going to be replaced, install a filler bracket and close the card retention latch.
NOTE:
You must install a filler bracket over an empty expansion card slot to maintain Federal Communications
Commission (FCC) certification of the system. The filler brackets also keep dust and dirt out of the system and aid
in proper cooling and airflow inside the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components
55