Table of Contents
Advertisement
Figure 88. Removing a memory module
Next steps
Replace the memory
module.
Installing a memory module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card riser
4.
Remove the air
shroud.
NOTE:
The procedure to install the memory module is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Locate the appropriate memory module socket.
CAUTION:
Handle each memory module only by the card's edges, ensuring not to touch the middle of the
memory module or the metallic contacts.
2. If a memory module blank is installed in the socket, remove it.
NOTE:
Ensure the socket ejector latches are fully open, before installing the memory module.
3. Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the
memory module in the socket.
CAUTION:
To prevent damage to the memory module or the memory module socket during installation, do
not bend or flex the memory module; insert both ends of the memory module simultaneously.
NOTE:
The memory module socket has an alignment key that enables you to install the memory module in the socket in
only one orientation.
CAUTION:
Do not apply pressure at the center of the memory module; apply pressure at both ends of the
memory module evenly.
82
Installing and removing system components
Safety
instructions.
Before working inside your
2.
system.
Advertisement
Table of Contents
