Table of Contents
Advertisement
Figure 115. Removing the 2.5-inch rear drive cage
Next steps
Replace the 2.5-inch rear drive
Installing the 2.5-inch rear drive cage
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If required,
remove the air
4.
Remove the
drives.
5. Disconnect the cables from the rear drive cage.
Steps
1. Align the slot on the rear drive cage with the guide on the system.
2. Slide the rear drive cage towards the rear of the chassis.
3. Using a Phillips 2 screwdriver, tighten the blue thumbscrew that secures the rear drive cage to the system.
cage.
Safety
instructions.
Before working inside your
shroud.
system.
Installing and removing system components
149
Advertisement
Table of Contents
