Table of Contents
Advertisement
Figure 118. Tightening the system board screws in sequence
Next steps
1. Replace the following components:
a.
Trusted Platform Module
b.
NOTE:
The TPM Module must be replaced only while installing a new system board.
c.
Internal USB memory key (if installed)
d.
Processor and heat sink module
e.
M.2 BOSS card
f.
Memory modules
g.
Expansion card riser 3
h.
Drive cage
i.
Expansion card riser 1
j.
Air shroud
k.
Expansion card riser 2
l.
Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable
securing brackets.
2. Ensure that you perform the following steps:
a. Use the Easy Restore feature to restore the Service Tag. See the
feature
section.
b. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the
update the Service Tag by using System Setup
c. Update the BIOS and iDRAC versions.
Re-enable the Trusted Platform Module (TPM). See the
3. If you are not using Easy restore, import your new or existing iDRAC Enterprise license. For more information, see the iDRAC
User's Guide available at
4. Follow the procedure listed in
Restoring the system using Easy Restore
The Easy Restore feature enables you to restore your service tag, license, UEFI configuration, and the system configuration data
after replacing the system board. All data is backed up in a backup flash device automatically. If BIOS detects a new system
board, and the service tag in the backup flash device, BIOS prompts the user to restore the backup information.
About this task
Below is a list of options/steps available:
● Restore the service tag, license, and diagnostics information, press Y
https://www.dell.com/idracmanuals
After working inside your
Restoring the system by using the Easy Restore
section.
Upgrading the Trusted Platform Module
.
system.
Installing and removing system components
Manually
section.
107
Advertisement
Table of Contents
