Table of Contents
Advertisement
4. Press the memory module with your thumbs until the ejectors firmly click into place. When the memory module is properly
seated in the socket, the levers on the memory module socket align with the levers on the other sockets that have memory
modules installed.
Figure 89. Installing a memory module
Next steps
1.
Install the air
shroud.
2.
Install the expansion card riser
3. Follow the procedure listed in
4. To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System
BIOS > Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of
the installed memory.
5. If the System Memory Size is incorrect, one or more of the memory modules may not be installed properly. Ensure that the
memory modules are firmly seated in their sockets.
6. Run the system memory test in system diagnostics.
Processor and heat sink module
This is a service technician replaceable part only.
Removing a processor and heat sink module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card riser
4.
Remove the air
shroud.
NOTE:
The heat sink and processor are hot to touch for some time after the system has been powered down. Allow the
heat sink and processor to cool down before handling them.
NOTE:
The procedure to remove the processor and heat sink module is the same for Rear Accessed and Front Accessed
configurations.
2.
After working inside your
Safety
instructions.
Before working inside your
2.
system.
system.
Installing and removing system components
83
Advertisement
Table of Contents
