Stopping - SMA Sunny Island 5048 Installation Instructions Manual

Activation and Deactivation
5. After the device has been switched on, the slaves show
the following message on the display.
6. Press <ENTER> to start the slave. Then the following
message appears (until the master starts).
Even with the "#270.01 AutoStr" parameter set, the Sunny Island 5048 must be
manually started each time the device is switched on using the DC circuit breaker.
7. Press <ENTER>. A beep is heard, the Sunny Island 5048 starts and is operating.
The green (upper) LED is illuminated.
If the device unexpectedly displays an error, it must be remedied before the device
can be operated. For this purpose, refer to section 19 "Troubleshooting/Problem
Solving" (Page 143).

9.2 Stopping

Proceed as follows to set the Sunny Island 5048 to standby mode:
Note that all connected loads are no longer provided with electrical
energy once you have stopped the Sunny Island 5048.
1. Switch off all loads, as far as this is possible.
2. Press <ENTER> to stop the Sunny Island 5048. The
following message appears.
3. Hold <ENTER> pressed down and the remaining time is
shown using bars on the display.
4. The Sunny Island 5048 has been stopped and the
display shows the following message:
The green (upper) LED goes out.
Note that in standby mode there is still voltage present in the device (DC,
AC1, AC2).
Page 62 SI5048-11:EE4206
SMA
Technologie AG
STANDBY-To start
press <ENTER>
Ready
Wait for Master
Hold key to stop
################
Hold key to stop
###########
STANDBY-To start
press <ENTER>
Technical Description