Display Messages (Overview) - SMA Sunny Island 5048 Installation Instructions Manual

SMA
Technologie AG
If the password is not valid, the Sunny Island 5048 does not switch into the
installer level. In this case, recalculate and re-enter the installer password as
described in this section.
The installer level is switched back to the user level if
• the Sunny Island 5048 is switched off and on again (see section 9
"Activation and Deactivation" (page 61)),
• specific parameters are entered (e.g. the "#270.01 AutoStr" parameter)
that cause a restart,
• an incorrect password is entered and if
• no keys are pressed for a period of 5 minutes.

10.6 Display Messages (Overview)

The display has two lines each with 16 characters. The first line displays the menu
number and the menu name or where applicable, parameter name. The menu name is
supplemented or the added text is displayed (e.g. parameter value) in the lower line,
if required.
The following message is displayed in the Home Screen.
Direction of energy
flow and system status
Device assignment
In the upper line, a bar graph displays the total output or charging power.
A character to the right of the graph indicates the load status: Here, "]" stands for
nominal output. If the nominal load is exceeded, the character appears as ">".
The direction of energy flow and the system status are displayed on the left in the lower
line. Here, the symbols stand for the generator side ("generator/grid"), for "battery"
and for load side ("loads/Sunny Boys"). The arrows between the symbols indicate the
direction of energy flow.
The device assignment follows (master or slave, e.g. M1 or S1).
Next to this assignment, the status of the external sources is indicated with the following
symbol meanings:
*
Generator voltage and frequency are within the set limits.
Technical Description
Output power/charging power
[ ¿¿¿¿¿¿¿¿¿¿¿
À Á Â
Status of ext. sources
]
M1 * oo!
SI5048-11:EE4206
Operation
Load status
Warning
Relay2 status
Relay1 status
Page 73