Mounting The Device; Preparation; Lifting/Moving; Unpacking - SMA Sunny Island 5048 Installation Instructions Manual

SMA
Technologie AG

4 Mounting the Device

Take note of the required installation conditions listed below before mounting, installing
and commissioning the Sunny Island 5048.

4.1 Preparation

4.1.1 Lifting/Moving

The Sunny Island 5048 weighs 63 kg. Ensure that at least three people are
available for installing the device. Always wear personal protective
equipment (protective clothing, gloves, safety boots) to avoid the danger
of injuries.
The upper black ventilation flaps on the right and left side of the Sunny Island
5048 can be removed for transportation; carrying handles are located under
the flaps. The ventilation flaps are not mounted when the device is delivered. They
are inserted after the device is installed (they snap on).

4.1.2 Unpacking

Before installing the Sunny Island 5048 make sure that all parts are included in the
delivery.
• Carefully check the packaging and the Sunny Island 5048 for any signs of
damage.
• Ensure that all parts are included in the delivery (see section 2.4 "Scope of
Delivery" (Page 17)).
• Enter the type and serial number of the device into the "Warranty and Guaranty
Conditions" form.
• Keep the documents in a location where they will be easy to find later.
Remove the tape that covers both the outer and inner holes for the cable feed-
throughs. It prevents foreign objects from entering the housing during transport.
If something is missing or the Sunny Island 5048 has been damaged during shipment,
contact SMA Technologie AG immediately. For more information, please see section
22 "Contact" (Page 159).
Keep the packaging in case you need to return the battery inverter or its
accessories.
Technical Description
Mounting the Device
SI5048-11:EE4206 Page 27