Parameter Display - SMA Sunny Island 5048 Installation Instructions Manual

SMA
Technologie AG
• Bar graph for output power or charging power (the direction of energy flow is
displayed by the arrows in the lower line)
• Total effective power of inverter (cluster) [TotInvPwrAt]
• Total effective power of external source [TotExtPwrAt]
• Present battery charge state (SOC) [BatSoc]
• Remaining absorption time [AptTmRmg]
• Active charging process [BatChgOp]
The display of the lower line remains as previously described.
On the slave devices, only the bar graph is displayed for output power or
charging power and in the lower line, the device assignment (e.g. S1 for slave 1)
and where applicable, the status of external sources (*, for a description, please
see further above) are displayed.

10.7 Parameter Display

Parameters on the Sunny Island 5048 are displayed as follows:
In the upper line, the parameter number comes first, then a
separator (hash) followed by the parameter name. In the
lower line, there is the value with the unit and the modification
mark (enter arrow) is on the far right.
If you would like to switch from a menu (regardless of whether it is a main or
submenu) into a parameter/value list, the menu numbers are not included on the
display.
The syntax specified here for menus and parameters apply to the entire document.
A menu is marked with a hash, menu number and menu name (#150 Grid
Meters).
A parameter is marked with a hash, menu number, dot and parameter number
(#150.01 GdRmgTm).
Technical Description
Operation
02#AptTmBoost
120 min
SI5048-11:EE4206
↵
Page 75