Activation And Deactivation; Activation / Startup - SMA Sunny Island 5048 Installation Instructions Manual

SMA
Technologie AG

9 Activation and Deactivation

9.1 Activation / Startup

This step assumes that the Sunny Island 5048 has been checked for
• correct (electrical) connections,
• voltages and polarities
and has already been put into operation by suitably qualified personnel
(qualified electrician).
1. Switch on the Sunny Island 5048 by switching the DC circuit breaker to the "ON"
position.
2. The Sunny Island 5048 starts the startup phase. Wait for
the following displays.
As soon as the startup phase is finished, the message "To init
system hold <Enter>" is displayed.
3. If you would like to access the QCG, press and hold
<Enter> until the Sunny Island 5048 beeps three times.
Then the following display message appears (on how to
proceed further, see section 8.2 "Starting the Quick
Configuration Guide (QCG)" (Page 57)).
4. If you do not press <ENTER> within 5 seconds, the
Sunny Island 5048 skips the QCG and shows the
following message.
Start the slaves before you start the master device.
Technical Description
Activation and Deactivation
SIBFSBOOT V1.000
SMA SMA SMA SMA
SMA SMA SMA
SI5048
@SMA 2006
To init system
hold <Enter>
01#StartMenu
New System
Standby-To start
press <ENTER>
SI5048-11:EE4206
↵
Page 61