Electrical Connection
1.
Pierce a hole in the rubber terminal area at the corresponding position.
2.
Starting from the outside, feed the cable with cable end sleeves through the hole.
3.
Insert one wire with the cable end sleeves in each of the "DIGIN" connection
terminals of the provided 4-pole print terminals and tighten the screws of these
terminals.
4.
Insert the 4-pole print terminal into the corresponding (upper) socket.
For more information on connecting and operating the GenMan, please see the
corresponding product documentation.
Page 50
SI5048-11:EE4206
SMA
Technologie AG
Technical Description