Section 3-5 Completing The Installation; Transducer Connection - GE LOGIQ 100 PRO Technical Publication

GE H
EALTHCARE
D 5305880-100, R
IRECTION
Assembling LOGIQ™ 100 PRO (Contd.,)
Figure 3-4 Assembling LOGIQ™ 100 PRO

Section 3-5 Completing the Installation

3-5-1

Transducer Connection

1.) Connect a transducer to transducer receptacle as follows,Refer to fig 3-4
Note:
2.) Connect the main power cable to a hospital grade power receptacle with the proper rated
voltage. Never use a three-to-two prong adapter; this defeats the safety ground.
Page 3-6
Ap p r o v e d Do c u m e n t - 5 3 0 5 8 8 0 - 1 0 0 T PH_ r 3 . p d f Pa g e 5 1 o f 1 9 7
3
EVISION
A.) Ensure that the transducer twist lock lever points towards the top of the probe
connector.
B.) Insert the transducer connector on the receptacle guide pin until it touches the
receptacle mating surface.
C.) Twist the transducer twist lock lever in the clockwise direction to lock it in place. Twist
the lever in anti clockwise direction to disconnect the transducer.
It is not necessary to turn OFF power to connect or disconnect a transducer.
Section 3-5 - Completing the Installation
LOGIQ™ 100 PRO S
ERVICE
M
ANUAL