Setting Modes (Mx1 Series) - Panasonic Urban Multi MX1R Series Service Manual

PACD011001C2
1.4

Setting Modes (MX1 Series)

The three setting modes are as follows:
‹ Setting mode 1 .....
‹ Setting mode 2 .....
‹ Monitor mode .....
Mode Changing The flow of the setting modes is as follows. (See the following pages for details.)
Procedure
Push the MODE button.
Monitor mode
Monitor item selection
Push
the RETURN
button.
Contents display
Push
the RETURN
button.
Push
the MODE
button.
„ You can make your selections with the SET button.
„ If you become unsure of how to proceed, push the MODE button and return to setting mode 1.
„ You don't have to perform power supply reset after changing settings in setting mode 1 (including [SS1]
Test Operation Urban Multi "MX1, ME1 Series" Using R-22
Mode for selecting cool/heat setting method, and whether or not to use low noise
operation and sequential start.
(H1P off)
Mode for changing operating status and setting addresses; used primarily for
service.
(H1P on)
Mode for checking setting made in the setting modes, number of connected
units, etc.
(H1P flickers)
Setting mode 1
Cool/heat selection
Set
Low noise operation
selection
Sequential start
selection
cool/heat selection switch on the outdoor unit PC board) and setting mode 2.
Push and hold the MODE button for 5 sec.
(Initial setting)
Push
the SET
button.
Set
Push
the RETURN
button.
Set
Push
the RETURN
button.
Set
Push
the RETURN
button.
Set
Test Operation
Setting mode 2
Setting item selection
Set
Push
the RETURN
button.
Setting contents
selection
Set
Push
the RETURN
button.
Setting contents
display
Push
the RETURN
button.
Push
the MODE
button.
(VF015)
67