Panasonic Urban Multi MX1R Series Service Manual page 95

Test Operation
1.5.1 Setting Mode 1
TEST C/H SELECT
MODE
HWL
IND
H1P H2P H3P
SET
Change cool/heat
selection to MASTER.
TEST C/H SELECT
MODE L.N.O.P.
HWL IND MASTER SLAVE
H1P H2P H3P H4P H5P H6P
Change low noise operation to "ON".
BMS interface adaptor for outdoor unit is required
if low noise operation is set to "ON".
Change sequential start to "OFF".
Setting complete
GROUP MASTER (cool/heat selection),
ON (low noise), OFF (sequential start)
MODE
Monitor mode
74
SEQ.
L.N.O.P.
START
MASTER SLAVE
H4P H5P H6P H7P
An optional BMS interface adaptor for outdoor unit is required
if you have set cool/heat selection to MASTER or SLAVE.
TEST
SEQ.
MODE
START
HWL
SET
H7P H1P H2P
TEST
MODE
HWL
H1P H2P
TEST
MODE
HWL
H1P H2P
TEST
MODE
HWL
H1P H2P
The factory settings are:
Individual (C/H SELECT), OFF (L.N.O.P.), ON (SEQ. START)
You can change the low noise and
sequential start settings by pushing the SET switch.
To skip settings you don't want to change, push the RETURN switch
and go to the next setting.
SET
C/H SELECT
SEQ.
L.N.O.P.
START
IND MASTER SLAVE
SET
H3P H4P H5P H6P H7P
RETURN
SET
C/H SELECT
SEQ.
L.N.O.P.
START
IND MASTER SLAVE
SET
H3P H4P H5P H6P H7P
SET
C/H SELECT
SEQ.
L.N.O.P.
START
IND MASTER SLAVE
SET
H3P H4P H5P H6P H7P
RETURN
C/H SELECT
SEQ.
L.N.O.P.
START
IND MASTER SLAVE
H3P H4P H5P H6P H7P
MODE
Setting mode 2
Test Operation Urban Multi "MX1, ME1 Series" Using R-22
PACD011001C2
TEST C/H SELECT
SEQ.
MODE L.N.O.P.
START
HWL IND MASTER SLAVE
H1P H2P H3P H4P H5P H6P H7P
TEST C/H SELECT
SEQ.
MODE L.N.O.P.
START
HWL IND MASTER SLAVE
H1P H2P H3P H4P H5P H6P H7P
RETURN
TEST C/H SELECT
SEQ.
MODE L.N.O.P.
START
HWL IND MASTER SLAVE
H1P H2P H3P H4P H5P H6P H7P
Push and hold for 5 sec.
(VF016)