Setting Modes (Me1R Series) - Panasonic Urban Multi MX1R Series Service Manual

Test Operation
1.5

Setting Modes (ME1R Series)

The three setting modes are as follows:
‹ Setting mode 1 ..... Mode for selecting cool/heat setting method, and whether or not to use low noise
‹ Setting mode 2 ..... Mode for changing operating status and setting addresses; used primarily for
‹ Monitor mode ..... Mode for checking setting made in the setting modes, number of connected units,
Mode Changing The flow of the setting modes is as follows. (See the following pages for details.)
Procedure
Push the MODE button.
Monitor mode
Monitor item selection
Push
the RETURN
button.
Contents display
Push
the RETURN
button.
Push
the MODE
button.
„ You can make your selections with the SET button
„ If you become unsure of how to proceed, push the MODE button and return to setting mode 1.
„ You don't have to perform power supply reset after changing settings in setting mode 1 (including [SS1]
288
operation and sequential start.
(H1P off)
service.
(H1P on)
etc.
(H1P flickers)
Setting mode 1
Low noise operation
selection
Set
Sequential start
selection
cool/heat selection switch on the outdoor unit PC board) and setting mode 2.
Push and hold the MODE button for 5 sec.
(Initial setting)
Push
the SET
button.
Set
Push
the RETURN
button.
Set
Push
the RETURN
button.
Set
Test Operation Urban Multi "MX1R, ME1R Series" Using R-407C
PACD011001C2
Setting mode 2
Setting item selection
Push
the RETURN
button.
Setting contents
selection
Push
the RETURN
button.
Setting contents
display
Push
the RETURN
button.
Push
the MODE
button.
.
Set
Set
(VF015)