Panasonic Urban Multi MX1R Series Service Manual page 123

Test Operation
Part Names and
Functions
1 Operation mode display
Displays status during operation.
• "Auto" can be set only for cool/heat simultaneous operation
systems.
2 Display programmed time
Displays programmed time.
3 Inspection / test operation display
When the inspection / test operation button is pushed, displays
whether the system is in the inspection or test operation mode.
4 Display air flow / flap
Displays "fixed" or "swing" for air direction.
5 Time mode START/STOP button
Push to start and stop the timer.
6 Timer ON/OFF button
Push to turn the timer on or off.
7 Inspection / test operation button
Push for inspection or test operation.
8 Programming time button
Push to set programming time.
9 Temperature control button
Push to set temperature.
10 Air flow direction adjustment button
Push to set the air flow direction to "fixed" or "swing."
11 Filter sign reset button
After cleaning the filter, push to cancel the air filter cleaning time.
12 Fan speed adjustment button
Each time this button is pushed, fan speed toggles between
"high" and "low."
∗ Works only for remote controller set to have cool/heat selection permission.
Note:
102
13 Operation mode selector button
Push to switch the operation mode. ∗Note
14 Defrost / hot start display
Displayed when defrosting.
15 Air filter cleaning time display
Displays the preset temperature when air condition operation
exceeds a certain period of time.
16 Display of fan speed
Displays set fan speed.
17 Display "under centralised control"
Displayed when under centralised control.
18 ON/OFF button
One push starts the system, and a second push stops the system
again.
19 Operation lamp (Red)
Lights during operation.
20 Display "changeover under control"
Cool/heat/auto/dry cannot be be switched with remote controllers
equipped with this display.
21 Preset temperature display
Displays the preset temperature.
22 Display ventilation/cleaning
Displayed when connected to dust collector, etc., equipped with
total heat exchanger unit.
23 Thermostat sensor in remote controller
Senses the room temperature near the remote controller.
Test Operation Urban Multi "MX1, ME1 Series" Using R-22
PACD011001C2