Settings Modes: Setting The Outdoor Unit Eeprom - Panasonic Elite Big PAC-i S-200PE3E5B Technical Data & Service Manual

6-6. Settings Modes: Setting the Outdoor Unit EEPROM

6. Mode Settings
 Setting mode 1
<Operating procedure>
(1) Press and hold the
(Ventilation) button simultaneously for 4
seconds or longer.
(2) Press the temperature setting
buttons to change the item code. The item codes
and setting data are shown on the next page.
(3) Press the timer time
change the setting data.
To confirm the changed setting data, press the
button.
(At this time, " " display stops blinking
and remains lit.)
(4) During this mode, "
blinking. The outdoor unit address display section
displays "ALL," the item code and number (DN
value in the table), and the setting data (6 digits).
(The setting data is displayed in 6 digits. The
display changes between the first 3 digits (Fig. (C)).
and the last 3 digits (Fig. (D)).
When the first 3 digits are displayed, the bottom dot
of the colon is illuminated.)
(5) To exit the setting mode, press the
button.
(Check) button and
and
and buttons to
" is displayed,
(Check)
Outdoor Unit Maintenance Remote Controller
Display of fi rst 3 digits
(C)
(2)
A
(3) (5)
(D) Display of last 3 digits
(2)
A
(3) (5)
(C) and (D) are displayed alternately.
(Example shows display of 000 001.)
6-11
2WAY SYSTEM
(1)
(1)
6