Panasonic Urban Multi MX1R Series Service Manual page 130

PACD011001C2
3. The second code No. is factory set to "01." The field set air flow position setting is however factory set to
4. Do not make settings other than those described above. Nothing is displayed for functions the indoor
5. "88" may be displayed to indicate the remote controller is resetting when returning to the normal mode.
1.18.3 Setting Contents and Code No.
UM Mode First
system No. Code
indoor Note 2 No.
unit
10(20) 0 Filter contamination heavy/light
settings
(Setting for display time to
clean air filter)
(Sets display time to clean air
filter to half when there is
heavy filter contamination.)
1 Long life filter type
(CS-LM only, 01 indicates long life)
2 Thermostat sensor in remote controller
3 Display time to clean air filter calculation
(Set when filter sign is not to be displayed.)
12(22) 0 Optional accessories output selection (field
selection of output for adaptor for wiring)
1 ON/OFF input from outside (Set when ON/
OFF is to be controlled from outside.)
2 Thermostat differential changeover
(Set when remote sensor is to be used.)
CS-LM, CS-UM, CS-DM, CS-TM only
3 OFF by thermostat fan speed
4 Automatic mode differential (automatic
temperature differential setting for UM
series heat recovery system cool/heat)
5 Power failure automatic reset
13(23) 0 High air outlet velocity
(Set when installed in place with ceiling
higher than 2.7 m.) CS-UM only
1 Selection of air flow direction
(Set when a blocking pad kit has been
installed.) CS-UM only
2 Horizontal air discharge
3 Air flow direction adjustment (Set at
installation of decoration panel.) CS-DM
only
4 Field set air flow position setting
5 Field set fan speed selection
(fan speed control by air discharge outlet
for phase control)
15(25) 1 Thermostat OFF excess humidity
3 Drain pump humidifier interlock selection
4 Sets whether filter sign is to be output by
time or by input.
5 Field set selection for individual ventilation
setting by remote controller
6 Field set selection for individual ventilation
setting by remote controller
Test Operation Urban Multi "MX1, ME1 Series" Using R-22
be set individually. Setting changes also cannot be checked.
"02."
unit is not equipped with.
Setting Contents
Super
long life
filter
Long life
filter
Standard
filter
Second Code No.(Note 3)
01 02
Light Approx. Heavy Approx.
10,000 5,000
hrs.
Approx. Approx.
2,500 1,250
hrs.
Approx. Approx.
200 hrs. 100 hrs.
Long life filter Super long life filter
Use No use
Display No display
Indoor unit turned
ON by thermostat
Forced OFF ON/OFF control
1°C 0.5°C
LL Set fan speed
01:0 02:1 03:2 4:03
Not equipped Equipped
N H
F (4 directions) T (3 directions)
Equipped Not equipped
Equipped Not equipped
Draft prevention Standard
Standard Optional
accessory 1
Not equipped Equipped
Not equipped Equipped
Time addition Input
Not equipped Equipped
Not equipped Equipped
Test Operation
03
—
hrs.
hrs.
—
—
—
Operation output Malfunction output
External protection
device
—
—
05:4 6:05 7:06
—
—
W (2 directions)
Ceiling Soiling
prevention
Optional accessory
2
—
—
—
—
—
04
—
Soot filter
—
—
—
08:7
—
—
—
—
—
—
—
—
—
—
—
—
109