Panasonic Urban Multi MX1R Series Service Manual page 304

PACD011001C2
1.4.2 Setting Mode 2
To enter setting mode 2 from setting mode 1 (normal), you must push and hold the MODE button (BS1) for
5 seconds. (Setting mode 2 cannot be entered while still making settings in setting mode 1.)
Setting Procedure
1. Push the SET button and match with the setting item (LED display). (All 10 settings)
↓
2. Push the RETURN button (BS3) and the present settings flicker (LED display).
↓
3. Push the SET button (BS2) and match with each setting (LED flicker display).
↓
4. Push the RETURN button (BS3) and enter the settings.
↓
5. Push the RETURN button (BS3) and return to the initial status.
„ If you become unsure of how to proceed, push the MODE button (BS1) and return to setting mode 1.
Note:
„ The initial status of setting mode 2 is the status of setting item No. 1 in mode 2.
Setting Items
∗ 1: Cannot be set with CU-5.
Note:
Test Operation Urban Multi "MX1R, ME1R Series" Using R-407C
Setting item Description
1 EMG Emergency
operation when
malfunction
occurs
2 Low noise / Address for low
demand noise / demand
address group operation
3 Forced fan Fan of stopped
switch indoor unit turns
4 Allows operation
Indoor unit
of indoor unit
forced
from outdoor unit
operation
5 Fixes the
Frequency
frequency of the
fix
inverter
compressor
5HP···68Hz
8.10HP··86Hz+ON
Low pressure
6
Te setting
setting for
cooling
High pressure
7
Tc setting
setting for
heating
Temperature
8
Defrost
setting for
setting
defrost
9
Not used Airnet address
LED display
H1P H2P H3P H4P H5P H6P H7P
Emergency operation
(Runs only by standard compressor)
Normal operation
Address
Binary number
(6 digits)
Forced fan operation
(H tap)
Normal operation
Indoor unit forced
operation
Normal operation
Frequency fix
Normal operation
High
Normal (factory set)
Low
Quick defrost
Normal (factory set)
Slow defrost
Address
Binary number
(6 digits)
Test Operation
LED display
H1P H2P H3P H4P H5P H6P H7P
0
1
2
31
0
1
2
63
(M029)
283