Startup Wizard - Huawei NetCol5000-A025 User Manual

NetCol5000-A025 In-row Air Cooled Smart Cooling
Product
User Manual (300 mm Width)
If the suction pressure, discharge pressure, and suction overheating degree is without normal
ranges, check and make sure that:
1. Charge refrigerant in an amount exactly as standard charge required. (Refrigerant charging
too much would result in high discharge pressure. Refrigerant charging too little would result
in low suction pressure, low discharge pressure, and high suction overheating degree.)
2. The air inlet and outlet of outdoor unit are without block. (The air inlet and outlet blockage
would result in high discharge pressure.)
If the problem remains unresolved after troubleshooting, contact Huawei technical support.
Step 6 After charging refrigerant, close all valves.
Step 7 Tap
Step 8 Tap Shutdown on the home screen and confirm it.
----End

4.5.6 Startup wizard

Prerequisites
Check that refrigerant is fully charged before performing the wizard startup.
Context
The startup wizard allows for commissioning of components such as the indoor
fan, electric heater, humidifier, condensate pump, and cooling system. It also
supports component automatic operation and automatic device checking, and can
output commissioning report.
After you power on the smart cooling product for the first time, the screen
displays the Wizard Startup screen. If the smart cooling product is not started for
the first time, choose Maint > Wizard Startup to enter the Wizard Startup
screen.
Tapping No or Exit, submission timeout, and system exception all result in
commissioning failures. Choose Maint > Wizard Startup to enter the Wizard
Startup screen for new commissioning.
Procedure
Step 1 On the home screen, choose Maint > Wizard Startup, as shown in
Issue 15 (2020-12-10)
NO TE
to exit the diagnostic mode.
NO TICE
Copyright © Huawei Technologies Co., Ltd.
4 Power-On Commissioning
Figure 4-36.
161