Operation; Check Point Before Operation; Check Points For Preset And Pattern Function Before Operation - LEGRAND 430 521 Instruction Manual

_________________________________________________________________________________

3 Operation

3.1 Check Points before Operation

Before turning on the system, check if the wire(s) and cable(s) are connected
properly.

Check if the camera ID on the controller is properly selected. The camera ID must
be identical to that of the target camera. The camera ID can be checked by reading
the DIP switch of the camera or on OSD.

If your controller supports multi-protocols, the protocol must be changed to match
to that of the camera.

Adjust the DIP switch after turning off the camera. If you changed the camera
protocol by changing the DIP S/W, the change will be effective after you reboot
the camera.

Since the operation method can be different by controllers, refer to your
controller manual if the camera can not be controlled properly. The operation of
this manual is based on the standard Pelco® Controller.
3.2

Check Points for Preset and Pattern Function before Operation


Check fully how to operate preset function and pattern function with your
controller or DVR in advance to operate the camera functions when using a
controller or a DVR.

Refer to the following table when using standard Pelco® protocol controllers.
< Go Preset >
< Set Preset >
< Run Pattern >
< Set Pattern >

If your controller or DVR has no pattern button or function, use the Hot Keys with
preset numbers. For more information, refer to " Reserved Presets(Hot Keys) " in
this manual.
Input [Preset Number] and press [Preset] button shortly.
Input [Preset Number] and keep pressing [Preset] button for
more than 2 seconds.
Input [Pattern Number] and press [Pattern] button shortly.
Input [Pattern Number] and keep pressing [Pattern] button for
more than 2 seconds.
42