3. (If present) Connect the M.2 SSD interface board cable to the slim-line connector on the server board
below the back edge of the air duct (see
4. Locate the air duct lock bar.
Orient Pin to
Front
5. Orient the lock bar so that the pin identified in
6. Using both hands, squeeze together and hold the lock bar latches (see Letter A).
7. Lower the lock bar into place ensuring the alignment pins found on both ends of the lock bar slide
into the matching slots on the chassis (see Letter A).
8. Release the lock bar latches and ensure the lock bar is securely locked in place (see Letter B).
Intel® Server System M70KLP Family Service Guide
Figure
Figure 10. Air Duct Lock Bar Orientation
Figure 11. Air Duct Lock Bar Installation
9).
Figure
10, is closest to the front of the chassis.
18