Figure 100. Installing Processor Carrier Clip Onto Processor - Part 2; Figure 101. Processor Heat Sink Handling - Intel M70KLP Series Service Manual

Figure 100. Installing Processor Carrier Clip onto Processor – Part 2
1. With the processor still in its tray, place the processor carrier clip over the processor.
2. Ensure the pin 1 indicator on the processor carrier clip is aligned with the pin 1 indicator of the
processor.
3. Gently press down simultaneously on two opposite sides of the processor carrier clip until it clicks in
place.
4. Repeat step 3 for the other two sides.
5. Locate the processor heat sink. To avoid damage, grasp it by its narrower sides as shown in
6. Place the heat sink bottom side up onto a flat surface.
If reusing an existing heat sink
• Properly clean off existing thermal interface material (TIM) from the bottom of the heat sink
• Apply new TIM (DOWSIL™ TC-5888)
If using a new heat sink
• Remove the plastic protective film (if present) from the Thermal Interface Material (TIM).
77
Intel® Server System M70KLP Family Service Guide

Figure 101. Processor Heat Sink Handling

Figure 101.