Adjusting The Lift Time (Height Of Lift) In The "Setup" Mode - Soyer BMS-9 Operating Instructions Manual

11.1.3 Adjusting the lift time (height of lift) in the "Setup" mode

Adjustment of the height of lift/lift time refers only to special gap welding guns with lifting
magnets (not the -K types). For these guns, the stud is lifted for a defined height/time
just before the welding process and is then automatically lowered during the welding
process.
As the height of lift of the stud is difficult to measure, the equivalent lift time is specified
on the stud welding device.
In the following setting of the lift time, the welding process is simulated in the "Setup"
mode. The lifting and lowering of the stud is the same as during welding, only the
welding current is not activated.
Operating modes


Danger from incorrect operating mode
If the following adjustment work is not carried out in the "Setup" mode but in the
operating mode, a weld is carried out by pressing the release button on the gun.



Adjusting the lift time/height of lift
Step 1:
Step 2:
Step 3:
42
Setup mode: No welding is carried out when simulating a welding process.
Operating mode (normal mode): Welding is carried out.
If a contact welding gun (K type) is connected when the "Setup" mode is
started, "Con" is shown on the display for approx. 3 seconds and the normal
mode starts automatically. There are no lifting magnets for contact welding
guns.
If the control plug of the gun is disconnected during the lifting test, the device
displays "Con" for approx. 3 seconds and automatically starts the operating
mode.
You are in the operating mode when no gun type is not shown on the display
after switching over to the "Setup" mode.
Connect the device as described in chapter "10.2 Connection of the stud
welding device and the stud welding guns" on page 36.
Check that the stud welding device is switched off.
Insert a welding stud into the gun.
Operating instructions Soyer Bolzenschweißtechnik