Cold Settings For Multistage Mode ("Lo 2-Stage", "Lo 3-Stage", "Ho 2-Stage" And "Ho 3-Stage"); Intensity Of Flame During Curve Settings - Siemens LMV37.4 Series Basic Documentation

The warm settings for air-fuel ratio control of the LMV37.4... have now been configured.
27.11.12 Cold settings for multistage mode («Lo 2-stage», «Lo 3-stage», «Ho 2-
stage» and «Ho 3-stage»)


27.11.13 Intensity of flame during curve settings

When setting the curve and the curvepoint is displayed, you can press
When pressing the button for >1 s, a change to parameter 954 is made; when releasing the button, you
return to the curvepoint.
/reset
Building Technologies Division
Industry Sector
P
V h min s %
Note
Refer to chapters Warm settings for «Lo 2-stage» and «Lo 3-stage»! But with no
flame, no actuator travel and no automatic operation after the settings have been
made.
P
V
h min s %
P
V h min s %
Basic documentation LMV37.4...
27 Parameter level
ESC
to show the intensity of flame.
/reset
Example: Curvepoint Low-flame position P1.
Change to parameter 954
/reset
>1 s
Parameter 954: flashes.
The intensity of flame in % is shown on the right.
Example: 954: 0.0
Release to return to curvepoint Low-fire
/reset
position P1.
203/235
CC1P7546en
20.09.2013