Editing The Curvepoints - Siemens LMV37.4 Series Basic Documentation

27.11.8

Editing the curvepoints


To the next curvepoint
F
F
and
or
A
A
and
or
To the next curvepoint
194/235
Building Technologies Division
Industry Sector
Note
To check the change on the burner, a curvepoint change in the cold settings
necessitates a new approach of all curvepoints in the warm settings. After changing
the curvepoint, OFF UPr appears on the normal display of the AZL2...
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
Basic documentation LMV37.4...
27 Parameter level
or
The selected curvepoint is displayed.
%
Keep depressed.
F
The fuel actuator has been selected for
editing.
%
Keep depressed and press
F
adjust the fuel actuator.
In the case of warm settings, the actuator
follows directly the adjustments made.
%
The changes are saved.
After releasing
again.
%
Keep depressed.
A
The air actuator has been selected for editing.
%
Keep depressed and press
A
adjust the air actuator.
In the case of warm settings, the actuator
follows directly the adjustments made.
%
The changes are saved.
After releasing
again.
%
To select the curvepoint
or to
, the curvepoint is selected
F
or to
, the curvepoint is selected
A
Back to the previous
curvepoint
CC1P7546en
20.09.2013