Warm Settings For "Lo 2-Stage", "Lo 3-Stage", "Ho 2-Stage" And "Ho 3-Stage - Siemens LMV37.4 Series Basic Documentation

27.11.11 Warm settings for «Lo 2-stage», «Lo 3-stage», «Ho 2-stage» and «Ho
Wait until the burner is operating and symbol ▲ or ▼ is no longer highlighted!
The startup sequence stops in phase 36 Traveling to ignition position.
The ignition position can be adjusted under cold conditions.
A
and
or
as well as
and
F A
and
or
Building Technologies Division
Industry Sector
3-stage»
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
Basic documentation LMV37.4...
27 Parameter level
Identification of start for setting the curve
parameters.
%
Provided the controller is enabled!
/reset
Phase Standby (stationary)
%
Phase Fan ramp up (fan motor = ON, safety
valve = ON)
%
Phase Traveling to prepurge
%
Phase Prepurging
%
Phase Traveling to ignition
%
Ignition position P0 can be set only when
symbol ▲ or ▼ is no longer highlighted.
Keep depressed and, for VSD
A
Press or
%
When symbol ▲ or ▼ is no longer highlighted,
the next curvepoint P1 can be selected with
.
position
position
and
F A
to adjust the value.
199/235
CC1P7546en
20.09.2013
.