27.4 Change of OEM's password
P
P
/reset
P
/reset
P
P
27.5 Use of parameter level
The parameters stored in the LMV37.4... basic unit can be displayed and changed on the parameter level.
Normally, all parameters have been set by the burner manufacturer – with the exception of those for the fuel
train and for air-fuel ratio control.
A description of parameter level 400, which is used for setting the fuel train and the fuel-air ratio curve, is
given in chapter Air-fuel ratio curves – settings and commissioning.
Building Technologies Division
Industry Sector
V
h min s
%
V
h min s
%
V
h min s
%
V
h min s
%
V
h min s
%
Basic documentation LMV37.4...
27 Parameter level
Parameter 042: flashes.
Press
to go to level c: for password changes.
/reset
Letter n: for new.
Proceed as described in chapter Entry of password and
enter the new password (5 characters).
After entry of the last character, the password must be
confirmed by pressing
.
/reset
Letter r: for repeat.
Proceed as described in chapter Entry of password and
repeat entry of the new password.
After entry of the last character, the password must be
confirmed by pressing
.
/reset
SEt confirms that the new password has been saved.
Parameter 042: flashes again.
171/235
CC1P7546en
20.09.2013