Table of Contents
Advertisement
10
Parameter Setting Method
You can use the knob or enable the touch screen to set the parameters of MSO8000A
series. The common parameter setting methods are as follows:
Method 1:
For the parameters with the sign
panel directly to select the parameter item or modify the parameter value.
Method 2:
For the parameters with the sign
panel and then press it down to select the parameter item or modify the parameter
value.
Method 3:
For the parameters with
on the front panel directly to set the parameter, or press down the multifunction knob
or the specified menu softkey, and then the numeric keypad is shown in
10.1
below.
In the numeric keypad, rotate the multifunction knob
press down the knob to select it. Then input the value or the unit. You can also enable
the touch screen and tap the value or unit in the numeric keypad to input them. After
you input all the values and select the desired units, the numeric keypad is turned off
automatically. This indicates that you have completed parameter setting. Besides,
after you have input the values, you can also press OK directly to confirm the input
and close the numeric keypad. At this time, the unit of the parameter is the default
unit. In the numeric keypad, you can also perform the following operations:
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
, rotate the multifunction knob
, rotate the multifunction knob
displayed on the menu, rotate the multifunction knob
Figure 10.1 Numeric Keypad
Parameter Setting Method
on the front
on the front
Figure
Parameter Input Field
Delete Key
Max. Value
Min. Value
Default Value
Clear Key
to select the parameter, then
23
Advertisement
Table of Contents
