Table of Contents
Advertisement
The following example assigns two SCSI failover disks to all
arrays. If you assign only one SCSI disk as a failover device, ensure
that there is sufficient freespace. If you assign more than one SCSI
disk as failover devices, you need ensure that only one of these
disks has sufficient space. The reason for this is that the failover
operation will look for the disk that has enough space.
AAC0>container set global_failover (1,2,0) (1,3,0)
Executing: container set global_failover (CHANNEL=1,ID=2,LUN=0)
(CHANNEL=1,ID=3,LUN=0)
Use the
container show failover
the /global switch) after using the container set failover
command to display information about the array(s) just assigned
failover disk(s), as in the following example:
AAC0>container show failover /global
Executing: container show failover /global=TRUE
container Scsi C:ID:L
--------- ----------------------------------
GLOBAL
1:02:0
As the example shows, the display indicates that SCSI devices
(1,2,0) and (1,3,0) are assigned as failover devices for all arrays (the
word GLOBAL appears in the array column).
Related Commands
container commands:
I
container list
I
container remove failover
I
container remove global_failover
I
container set failover
I
container show failover
1:03:0
(page
3-50)
container Commands
command (with or without
(page
3-80)
(page
(page
3-95)
(page
3-108)
3-84)
3-98
Advertisement
Table of Contents
