Table of Contents
Advertisement
controller Commands
controller show array_verify
To display the array verify status (enabled or disabled) for the
specified controller, use the controller show array_verify
command.
Syntax
controller show array_verify
Examples
Before turning the array verify feature on or off, check its status by
using the controller show array_verify command.
The following example shows that the controller's automatic
failover is currently enabled. The command also displays the
number of errors (if any) found as a result of the array verify
operation.
AAC0> controller show array_verify
Executing: controller show array_verify
Array verify ENABLED
Errors found 0
Related Commands
controller commands:
I
(page
controller set array_verify
4-19)
4-25
Advertisement
Table of Contents
