Adaptec AAR-2020SA Reference Manual page 93

Examples
Before renumbering an array, use the container list
command to obtain information about any existing arrays. As the
following example shows, there is an array 0 (a volume set) on this
controller:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 20.0MB
The following example renumbers array 0 to array 5:
AAC0>container move 0 5
Executing: container move 0 5
Use the container list command after using the container
move command to display information about the array you just
renumbered, as in the following example:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 5 Volume 20.0MB
As a result of renumbering array 0 to array 5 with the container
move command, the Num Label column displays ID number 5
instead of 0. This column also displays the label assigned to the
array when the array was created. If no label was assigned to the
array then no label appears in the column.
Related Commands
container commands:
I
container list
Total Oth Stripe
Size Ctr Size
Total Oth Stripe
Size Ctr Size
(page
Scsi
Usage C:ID:L Offset:Size
NTFS 0:02:0 64.0KB:
0:03:0 64.0KB:
Scsi
Usage C:ID:L Offset:Size
NTFS 0:02:0 64.0KB:
0:03:0 64.0KB:
3-50)
container Commands
Partition
10.0MB
10.0MB
Partition
10.0MB
10.0MB
3-62