Table of Contents
Advertisement
Use the container list command after executing the
container create volume command to display information
about the volume set, as in the following example:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
0
Volume 15.0MB
The following list describes the columns that contain information
as the result of creating a volume set with the container create
volume command:
I
The Num Label column displays the ID number of the newly
created volume set, which in the example is 0.
If you specify a label when creating the volume set, it appears
in this column. Because no label was specified when the
volume set was created, no label appears in the column.
On UNIX systems, the root special file associated with the
array also appears in this column.
I
The Type column displays Volume to indicate that the newly
created array is a volume set.
I
The Total Size column displays the value(s) specified in the
free_space
I
The Usage column displays None to indicate that the newly
created volume set does not have a file system on it. To create
an NTFS or FAT file system on an array, use the
command.
format
I
The Scsi C:ID:L column displays the SCSI device ID for the
disk on which you created the volume set, which in the
example is 0:02:0.
I
The Partition Offset: Size column displays the partition
offset and the size of the newly created volume set's partition,
which in the example are 64.0 KB and 15.0 MB. The size is the
size you specified in the
Related Commands
container commands:
I
container extend volume
I
container format
Total
Oth Stripe
Size
Ctr Size
parameter(s), which in the example is 15.0 MB.
free_space
(page
Scsi
Usage
C:ID:L Offset:Size
None
0:02:0 64.0KB:
parameter(s).
(page
3-47)
3-50)
container Commands
Partition
15.0MB
container
3-35
Advertisement
Table of Contents
