enclosure set door
To lock or unlock a specific door on a specific SAF-TE enclosure
management device, use the enclosure set door command.
Syntax
enclosure set door [/lock{=boolean}] {enclosure}
{door}
Parameters
{enclosure}
Specifies the ID associated with the enclosure management
device on which you want to lock the door. For this version,
the controller supports a maximum of eight enclosure
management devices on each bus.
{door}
Specifies the unit number of the door for which you want to
set the lock. This number can range from 0 to 15 inclusive.
Switches
/lock{=boolean}
Specifies whether to lock the door associated with the
specified unit number. If you set this switch to TRUE, the
command locks the door associated with the specified unit
number. If you set this switch to FALSE, the command
unlocks the door associated with the specified unit number.
This switch defaults to FALSE.
Examples
The following example locks the door associated with unit 1 on
enclosure management device 0:
AAC0>enclosure set door /lock=TRUE 0 1
Executing: enclosure set door /lock=TRUE 0 1
Related Commands
enclosure commands:
I
enclosure list
(page
9-6)
enclosure Commands
9-14