diagnostic moderation set timer
To set the default interrupt timer on the controller, use the
diagnostic moderation set timer command.
Caution:
!
technical support.
Syntax
diagnostic moderation set timer {integer}
Parameters
{integer}
Specifies the value (for example, 10) you want to set as the
default interrupt timer on the controller. The interrupt timer
is the delay time in 100 microsecond units before the
controller issues an interrupt to the host computer. For
example if the interrupt timer is set to 10, the controller
batches I/O request responses for one millisecond and issues
an interrupt to the host computer.
The default interrupt timer is 0 (zero).
Related Commands
diagnostic commands:
I
diagnostic moderation set count
I
diagnostic moderation show count
I
diagnostic moderation show timer
Use this command only under the direction of
diagnostic Commands
(page
6-7)
(page
6-9)
(page
6-10)
6-8