Table of Contents
Advertisement
disk verify
To verify all blocks on a SCSI disk device and, optionally, repair
any bad blocks, use the disk verify command.
Syntax
disk verify [/repair{=boolean}] [/wait{=boolean}]
{scsi_device}
Parameters
{scsi_device}
Specifies the ID for the SCSI disk device that you want to
verify. A SCSI ID consists of a SCSI channel number (for
example, 0, 1, 2, 3, etc.), a SCSI device ID (0 through 15
inclusive), and a SCSI logical unit number (0 through 7
inclusive).
For further details, see
Switches
/repair{=boolean}
Specifies whether to automatically repair bad blocks. If you
set this switch to TRUE, the command attempts to repair any
bad blocks. If you do not specify the switch, the command
only reports failures.
This switch defaults to FALSE.
/wait{=boolean}
Specifies whether to perform verification synchronously or
asynchronously. If you set this switch to TRUE, the command
performs the block verification synchronously and the
command prompt does not return until the block verification
operation completes.
The default is FALSE; that is, the command performs the
block verification asynchronously and the command prompt
returns immediately.
scsi_device on page
disk Commands
1-10.
5-29
Advertisement
Table of Contents
