Table of Contents
Advertisement
controller firmware compare
To compare the contents of each of the flash components on a
controller to the corresponding image in a pair of user flash image
(UFI) files and indicate whether they match, use the controller
firmware compare command.
Syntax
controller firmware compare
[/C[{controller_ID}][{controller_ID}...]
[/D{UFI_file_path}]
Switches
/C{controller_ID}
Specifies the controller ID representing the set of controllers
on which to perform the firmware comparison.
If you do not specify this switch, this command compares the
flash components on controller 0.
/D{UFI_file_path}
Specifies the path where the pair of UFI files are located.
If you do not specify this switch, this command compares the
flash components against the pair of UFI files in the current
default drive and directory.
Examples
The following example compares the contents of a controller's
flash components to the corresponding image in a pair of UFI files.
AAC0> controller firmware compare D:\
Executing: controller firmware compare "D:\"
The controller's firmware matches the firmware in the specified flash
image files.
Related Commands
controller commands:
I
controller firmware save
I
controller firmware update
controller Commands
(page
4-7)
(page
4-9)
4-6
Advertisement
Table of Contents
